(Formerly Chip McCormick Triggers) single-stage drop in Trigger and
hammer assembly. No cheap tricks or compromises: Full strength music
wire springs for fast lock-time & reliable discharge with factory or
military ammo. Fully machined tolerances of +/-.001" and through
hardened, the S-7 tool steel hammer, Trigger, disconnector and Pins are
made with the highest grade, hardest, longest wearing material
available. You won't get this kind of quality, performance and service
life with inferior surface hardened cast parts!
Housing is 410 stainless steel. Factory
tuned for a better than average match grade Trigger pull with minimum
take-up and over-travel. Typical quality Chip McCormick is famous for!
Self contained parts slide easily into receiver and Pin into position.
The easiest, fastest way to get an AR Trigger job!
These completely self-contained Trigger
group assemblies are factory tuned for a super match grade Trigger pull
with minimum take-up and overtravel. The innovative design provides
unprecedented control, ergonomics and consistency.
Constructed of a stainless steel outer
casing and steel internal parts for dependable operation. Pre-set
Trigger pull is 3 to 3-1/2 lbs. Trigger drops in, but may need to be
function checked by a qualified gunsmith. May require minor fitting.
Fits Small Pin (.154") AR-15 only.
Fits Mil-Spec receivers.